IONIC Hydro Bloom one-part hydroponic flowering nutrient by Growth Technology

IONIC Hydro Bloom – One-Part Hydroponic Flowering Nutrient – Growth Technology

1 Litre
£14.49
Pomiń, aby przejść do informacji o produkcie
IONIC Hydro Bloom one-part hydroponic flowering nutrient by Growth Technology

IONIC Hydro Bloom – One-Part Hydroponic Flowering Nutrient – Growth Technology

£14.49
Size

Type: Mineral
Mineral feeds are dissolved minerals your plant can use straight away. They're fast-acting and precise, but it is possible to overdo them, so stick to the dose.

The Flowering Feed That Stops Asking for Your Attention

Flowering is when plants are at their most demanding and growers are at their most nervous. It's the stage where every feed matters and every pH swing feels personal. The cruel irony is that most bloom feeds add to the anxiety, with two or three bottles to balance and a reservoir pH that drifts the moment you look away.

IONIC Hydro Bloom takes the opposite approach. It's a complete flowering nutrient in a single bottle, with the potassium to nitrogen ratio shifted for flowers, fruit and yield. The pH is so stable that most tanks need no adjusting at all, so you spend the flowering weeks watching plants rather than meters.

Why It Works

  • Built for flowering and fruiting: the K to N ratio is set for flowering and yield.
  • One bottle, complete: no A&B to measure out, no risk of mixing parts in the wrong order.
  • pH that stays put: stable enough that most tanks need no adjusting.
  • Suits all hydroponic systems: NFT, flood & drain, drip, DWC, rockwool and inert media.
  • A little goes a long way: at 5–6ml per litre, a 1 litre bottle makes roughly 165–200 litres of feed.

For Houseplant & Kitchen Growers

Growing tomatoes, chillies or strawberries in a countertop hydro kit or a bucket system? Swap to IONIC Hydro Bloom once your plants start to flower. It gives fruiting plants the potassium-rich diet they need to set and ripen fruit, without the complexity of a multi-part feed.

For Growers

The flowering base feed for hydro on soft or RO water. Run vegetative growth on IONIC Hydro Grow, then switch when flowering starts. On hard or mains tap water, use IONIC Hard Water Bloom instead.

  • Dose: 6ml/L, tapering to 5ml/L through flowering.
  • When to use: weeks 6–12, with a water-only flush in week 13.
  • Boosters: add IONIC Tonic at 0.5ml/L from week 6 and IONIC PK at 1ml/L from week 8.
  • Pairs with: IONIC Cal-Mag Pro. You'll get 10% off the Cal-Mag Pro when you buy the two together.

Rose's Pro-Tip: Add products to the tank one at a time and stir between each. Never mix concentrates neat. And keep the tank covered, because light in a stored nutrient solution eventually means algae.

Which Size?

  • 1 Litre: ideal for a home hydro kit or small system
  • 5 Litres: for a full tent or larger system
  • 20 Litres: the best value for big setups

Specifications

  • Type: one-part mineral base nutrient, flowering stage
  • Water: soft or RO water (hard water? use IONIC Hard Water Bloom)
  • Dose: 5–6ml per litre
  • Suitable for: all hydroponic systems
  • Sizes: 1 Litre, 5 Litres, 20 Litres

You may also like