Quick Release Ducting Clips – 4" to 12" Duct Clamps, Singles & Packs of 5 (Jubilee)
The weakest point in any ventilation system isn't the fan or the filter. It's the joint between them. Ducting that's just pushed onto a spigot will creep, sag and eventually drop off, usually in the middle of the night, leaving your fan blowing into thin air. A ducting clip turns that loose push-fit into a joint that stays put.
These are quick-release clips. Instead of winding a long screw from fully open, you clip the band round the ducting, snap it closed, and give it a few final turns to tighten. Releasing it is just as quick, which makes swapping a filter or moving a fan a two-minute job.
Sizes
| Clip | Fits ducting |
|---|---|
| 4–5" (single) | 100–125mm (4" and 5") |
| 6–8" (single) | 150–200mm (6" and 8") |
| 10–12" (single) | 250–315mm (10" and 12") |
| 4" pack of 5 | 100mm ducting |
| 8" pack of 5 | 200mm ducting |
| 10" pack of 5 | 250mm ducting |
The singles each cover a range of two duct sizes. The 5-packs are sized for one duct diameter and work out much cheaper per clip if you are kitting out a whole system.
How many do I need?
Two per length of ducting, one at each end. A typical tent setup (filter, fan, ducting out) needs about four, which is why the packs of 5 are the popular choice.
Not just for growers
- Tumble dryer, kitchen and bathroom extractor hoses
- Portable air-con exhausts
- Workshop dust and fume extraction
🌿 Rose's Pro-Tip: clip it, then tape it. The clip holds the ducting on, and a wrap of aluminium tape over the joint seals the last little air leak. Together they make a joint that's both secure and airtight, which matters for odour control.
Joining two rigid flanges, such as fan to filter? Our anti-vibration Fast Clamps do that job better and quieter.
Black Flag Horticulture Ltd, Coventry.